1. Made as best as possible implementation of the status bits 1-2 of the Trantor 128 so to make a more accurate speed for SCSI devices (CD-ROM and HDD) without stalls.
2. Slightly reorganized the timer of the T128.
1. Make IRQ's more correct and per manual.
2. Only an adapter reset command should reset the SCSI devices connected to it.
3. Differentiate the two controllers by the connector bit (pos3 bit 12) in the CMD GET POS INFO SCB command.
4. Actually emulate bit 7 of pos4 in the pos writes so that selection between 16KB and 32KB rom loading is done properly.
5. Some cleanups.
PC Enterprises GameMaster, Resound jr (adlib)
MS Booster/PC Enterprises jrBus-Mouse, PC Enterprises GameMaster (bus mouse)
Various (generic) RTC
Corel LS2000 SCSI
1. Made logs more consistent.
2. Actually add Write and Verify command, used by IBM OS/2 1.2 Extended, and fixes a hang by said OS after inserting disk 6.
Apparently the Trantor T130B SCSI controllers has a different way of calculating the timings and removed the scsi_bus_read() calls from the Current SCSI bus status port (Read Port+4).
Fixes NT using said controller as well as CD swapping while maintaining the correct accurate CD speed.
1. Separate the SCSI bus functions from NCR 5380 into true general purpose SCSI bus functions, allowing use of future legacy scsi controllers.
2. Corrected NCR 5380 chip period for the SCSI controllers based on that chip so that CD-ROM speed is correct enough per speed tests and no more breakage (I hope, report if they are still there, please!) on desyncs.
3. A NCR 5380 software reset involves asserting an IRQ.
1. Sanity check for the SCSI temp_buffer if it's allocated or not.
2. Data reads and writes in non-DMA mode should be accessible only when DMA mode is Idle (as in, no DMA at all, whereas DMA mode will go to the SCSI controllers' callbacks).
1. Too many soft resets should not reset the SCSI layer, fixes CD Audio on the 53c90a MCA controller used by guests.
2. Implemented preliminary MDL S/G mode for the PCSCSI side.
3. The underflow DMA function is no longer needed as it now SCSI transfers on the 53c90a MCA controller works properly.
4. Minor corrections to the PCI side (mainly the revision).
5. The DMA 86c01 side of the MCA 53c90a controller is more polished now, should fix some more bugs.
1. The SCSI ID is now more correct about about the difference between physical unit number and actual SCSI ID. This should fix boot freezes on NT 1991 builds for x86 using said card, as well as keeping compatibility the same as before.
