Floppy disk controller is now COMPLETELY reset on hard reset;
NukedOPL is now optional (but enabled by default) so people on older hardware can gain a few % of performance by going back to DOSBox OPL;
*.CPP files now get all the correct optimization flags applied;
Added NEC PowerMate V emulation - you can get into CMOS SETUP but it hangs before booting, and PCI graphics card don't work (yet).
SCSI LUN is now selectable for the CD-ROM drives;
Made sure every BusLogic RequestSetup ends in a StartMailbox sooner or later, fixes freezes with the DOS BusLogic drivers;
Commented out execess logging from mem.c;
Applied the mainline PCem commit that fixes the Bahamas64 on some boards.
Fixed several ATAPI CD-ROM bugs;
Added some missing CPL override checks to the MMU translate functions;
Tertiary and quaternary IDE controllers are now automatically disabled if not a single device is attached to them;
Changed sleep time on compile from 10 seconds to 2 seconds.
Fixed IDE and ATAPI 8-bit data reads and writes by rewriting the IDE and CD-ROM PIO data read and write code so that the base code is now 8-bit;
Added some compiler directives that if set, will enable togglable logging and log breakpoints;
Empty IDE channels now always report a status of 0x10 rather than 0x20, and do it on port 3F6h/376h/36Eh/3EEh too, fixes OAKCDROM.SYS infinite loop when hitting an empty IDE channel.
Four CD-ROM drives are now emulated;
ATAPI DMA is now emulated;
Unified CD-ROM pass through to host drive handling;
Applied all (applicable) mainline PCem commits.
The port 92 handler in mem.c now flushes MMU cache when toggling the A20 gate;
Added ability to reload previous disc after ejecting it;
Fixed the START/STOP UNIT command for both SCSI and ATAPI;
Applied mainline PCem commit: All XT models can now use 64kb RAM. Patch from ecksemmess .
The tertiary and quaternary IDE controllers are now fully configurable;
The IRQ of the RTL8029AS network card is now configurable;
CopyQM floppy images are now supported.
Added experimental NVidia Riva TNT2 emulation (patch from MoochMcGee);
ASUS P/I-P54TP4XE, ASUS P/I-P55T2P4, and ASUS P/I-P55TVP4 are back;
National Semiconductor PC87306 Super I/O chip now correctly reenables devices after a chip power cycle;
Several FDC improvements and the behavior is now a bit closer to real hardware (based on actual tests);
Added MR Intel Advanced/ATX with Microid Research BIOS with support for 4 floppy drives and up to 4 IDE controllers;
Added floppy drives 3 and 4, bringing the maximum to 4;
You can now connect hard disks to the tertiary IDE controller;
Correct undocumented behavior of the LEA instruction with register is back on 286 and later CPU's;
Pentium-rea models with Intel chipsets now have port 92 (with alternate reset and alternate A20 toggle);
Overhauled DMA channel read and write routines and fixed cascading;
Improved IMG detection of a bad BPB (or complete lack of a BPB);
Added preliminary emulation of PS/2 1.44 MB and PC-98 1.25 MB 3-mode drives (both have an inverted DENSEL pin);
Removed the incorrect Amstrad mouse patch from TheCollector1995;
Fixed ATAPI CD-ROM disk change detection;
Windows IOCTL CD-ROM handler now tries to use direct SCSI passthrough for more things, including obtaining CD-ROM capacity;
The Diamond Stealth32 (ET4000/W32p) now also works correctly on the two Award SiS 496/497 boxes;
The (S)VGA handler now converts 6-bit RAMDAC RGB channels to standard 8-bit RGB using a lookup table generated at emulator start, calculated using the correct intensity conversion method and treating intensity 64 as equivalent to 63;
Moved a few options from the Configuration dialog box to the menu;
SIO, PIIX, and PIIX3 now have the reset control register on port CF9 as they should;
Several bugfixes.
The AHA-154x can now also use base addresses 0x130, 0x134, 0x230, 0x234, and IRQ's 14 and 15;
Reworked the SCSI system resource menu handlers in win.c a bit.
Removed the lone Misc menu and mvoed Status to Settings;
Added a SCSI CD-ROM option to the menu;
Removed the atapi_cdrom_enabled option and replaced any usage of it with !scsi_cdrom_enabled;
Disabling/enabling the CD-ROM drive is now separate from the drive's contents;
The tertiary IDE controller now never gets enabled is the CD-ROM drive is either disabled or SCSI.
Japanese HDI hard disk images are now supproted;
FDC FORMAT command now CRC's the correct data, fixes formatting inserted IMG's;
FDC SEEK command now no longer incorrectly reports invalid status when HDSEL (head select) is 1, fixes booting from inserted floppies of any format on boards other than ASUS P/I-P55TVP4.
Replaced IMG handler with one that now proxies to the 86F handler;
Applies the remaining Mainline PCem speedup commit;
Fixed the National Semiconductors PC87306 Super I/O Chip's serial port IRQ assignment;
DMF images are now loaded with the correct sector interleave, improving read/write speed;
XDF images are now loaded in a way that emulates the real order of the sectors on the track, improving read/write speed;
Added 16-bit physical memory read/write routines (mem_phys_readw, mem_phys_writew) and modified the 16-bit DMA code to use them instead of two 8-bit reads/writes.
Uncommented auto-setting FDC data rate to 250 kbps on non-AT machines; fixes floppies on IBM PC and XT and clones;
Removed flto flag from the makefiles, should speed up compile times and make the XT and earlier machines work again;
Removed CGA brown and color burst settings in line with mainline PCem.
