IMG floppy image handler now fills the remaining bytes with 0xF6 if it has read less bytes than expected - fixes handling of truncated IMG's with a valid BPB;
HDI files are now written with the correct header;
FDC DUMP REGISTERS command is now implemented correctly, fixes FDC error on AMI 486 clone and AMI WinBIOS 486;
Commented out the Acer 386SX and the Phoenix 386 clone;
WinPCap code is now delayed loading (thanks to Rai-chan), the emulator should now be able to run without WinPCap installed if not using PCap;
The IBM PS/2 Model 30 NVR file is now saved in the same directly as the other NVR files;
Applied all the latest mainline PCem Voodoo commits.
Added IBM PS/2 Model 30 emulation per mainline PCem patch from dns2kv2;
Commented out the Chips & Technologies VGA 451 as it needs further work;
Added the ability to disable XTIDE;
Prepared the icon that will be used for stable builds.
Added the Samsung SPC-4200P;
Added the Chips & Technologies VGA 451;
Applied all mainline PCem commits;
Added Amstrad MegaPC 386DX model (exits per documentation that I have in German).
Added write port 3C1 to EGA and (S)VGA, fixed Microsoft Word 2.0 for DOS;
The RTL8029AS now correctly enables I/O port range when base address is changed via PCI registers with I/O access enabled;
Tentative fix for DirectDraw <-> Direct3D switching issues based on proposal from TheCollector1995;
Fixed 64-bit makefile;
Fixed LZF_C.C so it can compile for 64-bit Windows;
Applied all mainline PCem commits.
Floppy disk controller is now COMPLETELY reset on hard reset;
NukedOPL is now optional (but enabled by default) so people on older hardware can gain a few % of performance by going back to DOSBox OPL;
*.CPP files now get all the correct optimization flags applied;
Added NEC PowerMate V emulation - you can get into CMOS SETUP but it hangs before booting, and PCI graphics card don't work (yet).
- Crash dumps now attempt to be created in the directory with 86Box.exe
- Crash dumps now attempt to find the full path + filename of the module
where the crash occured, and includes it if found
Fixed IDE and ATAPI 8-bit data reads and writes by rewriting the IDE and CD-ROM PIO data read and write code so that the base code is now 8-bit;
Added some compiler directives that if set, will enable togglable logging and log breakpoints;
Empty IDE channels now always report a status of 0x10 rather than 0x20, and do it on port 3F6h/376h/36Eh/3EEh too, fixes OAKCDROM.SYS infinite loop when hitting an empty IDE channel.
Four CD-ROM drives are now emulated;
ATAPI DMA is now emulated;
Unified CD-ROM pass through to host drive handling;
Applied all (applicable) mainline PCem commits.
Moved CD-ROM read data buffer declaration and definitions to SCSI source files and headers, but still applying to IDE when needed.
SCSI Read commands now return the correct sectors on callback.
DMA bug fixes.
Added experimental NVidia Riva TNT2 emulation (patch from MoochMcGee);
ASUS P/I-P54TP4XE, ASUS P/I-P55T2P4, and ASUS P/I-P55TVP4 are back;
National Semiconductor PC87306 Super I/O chip now correctly reenables devices after a chip power cycle;
Several FDC improvements and the behavior is now a bit closer to real hardware (based on actual tests);
Added MR Intel Advanced/ATX with Microid Research BIOS with support for 4 floppy drives and up to 4 IDE controllers;
Added floppy drives 3 and 4, bringing the maximum to 4;
You can now connect hard disks to the tertiary IDE controller;
Correct undocumented behavior of the LEA instruction with register is back on 286 and later CPU's;
Pentium-rea models with Intel chipsets now have port 92 (with alternate reset and alternate A20 toggle);
Overhauled DMA channel read and write routines and fixed cascading;
Improved IMG detection of a bad BPB (or complete lack of a BPB);
Added preliminary emulation of PS/2 1.44 MB and PC-98 1.25 MB 3-mode drives (both have an inverted DENSEL pin);
Removed the incorrect Amstrad mouse patch from TheCollector1995;
Fixed ATAPI CD-ROM disk change detection;
Windows IOCTL CD-ROM handler now tries to use direct SCSI passthrough for more things, including obtaining CD-ROM capacity;
The Diamond Stealth32 (ET4000/W32p) now also works correctly on the two Award SiS 496/497 boxes;
The (S)VGA handler now converts 6-bit RAMDAC RGB channels to standard 8-bit RGB using a lookup table generated at emulator start, calculated using the correct intensity conversion method and treating intensity 64 as equivalent to 63;
Moved a few options from the Configuration dialog box to the menu;
SIO, PIIX, and PIIX3 now have the reset control register on port CF9 as they should;
Several bugfixes.
FDI stream images are now also handled by the 86F handler;
Both floppy drives' motors now spin separately;
Added Plantronics ColorPlus emulation per patch from PCem forum;
Applied all mainline PCem commits;
Fixed several bugs.
Improved TeleDisk support;
Added support for ImageDisk (IMD) images;
Added MSR registers 186 and 570 for the Intel i686 CPU's;
Applied both mainline PCem commits.
Replaced IMG handler with one that now proxies to the 86F handler;
Applies the remaining Mainline PCem speedup commit;
Fixed the National Semiconductors PC87306 Super I/O Chip's serial port IRQ assignment;
DMF images are now loaded with the correct sector interleave, improving read/write speed;
XDF images are now loaded in a way that emulates the real order of the sectors on the track, improving read/write speed;
Added 16-bit physical memory read/write routines (mem_phys_readw, mem_phys_writew) and modified the 16-bit DMA code to use them instead of two 8-bit reads/writes.
Fixed the RTL8029AS again (one of my "fixes" broke it);
RTL8029AS PCI register 4 is now written to;
Added incomplete (and currently commented out) emulation of the AWE64 PCI;
Replaced sector-based floppy emulation with more accurate code.
