IMG floppy image handler now fills the remaining bytes with 0xF6 if it has read less bytes than expected - fixes handling of truncated IMG's with a valid BPB;
HDI files are now written with the correct header;
FDC DUMP REGISTERS command is now implemented correctly, fixes FDC error on AMI 486 clone and AMI WinBIOS 486;
Commented out the Acer 386SX and the Phoenix 386 clone;
WinPCap code is now delayed loading (thanks to Rai-chan), the emulator should now be able to run without WinPCap installed if not using PCap;
The IBM PS/2 Model 30 NVR file is now saved in the same directly as the other NVR files;
Applied all the latest mainline PCem Voodoo commits.
Added the Samsung SPC-4200P;
Added the Chips & Technologies VGA 451;
Applied all mainline PCem commits;
Added Amstrad MegaPC 386DX model (exits per documentation that I have in German).
Added write port 3C1 to EGA and (S)VGA, fixed Microsoft Word 2.0 for DOS;
The RTL8029AS now correctly enables I/O port range when base address is changed via PCI registers with I/O access enabled;
Tentative fix for DirectDraw <-> Direct3D switching issues based on proposal from TheCollector1995;
Fixed 64-bit makefile;
Fixed LZF_C.C so it can compile for 64-bit Windows;
Applied all mainline PCem commits.
The CD-ROM IOCTL direct pass through code now does sanity check on the requested data size before passing the command - fixes crashes with some DMA-only host DVD drives;
The network poller is now in its own thread;
The hack is back in the emulation of the National Semiconductors PC87306 Super I/O Chip - it's the only way right now to have serial working on that board;
Fixed a part of the code that was still using NukedOPL even when OPL 3 was set to DOSBox OPL;
Applied all mainline PCem commits.
Floppy disk controller is now COMPLETELY reset on hard reset;
NukedOPL is now optional (but enabled by default) so people on older hardware can gain a few % of performance by going back to DOSBox OPL;
*.CPP files now get all the correct optimization flags applied;
Added NEC PowerMate V emulation - you can get into CMOS SETUP but it hangs before booting, and PCI graphics card don't work (yet).
Improved the BusLogic incoming mailbox code;
The BusLogic callback is now three-phases and outgoing mailbox interrupts are emulated correctly;
Fixed the CD-ROM command READ DISC INFORMATION (0x51), fixes NetBSD crashing 86Box with segmentation fault when using the AHA-154x;
Added the CD-ROM command PAUSE/RESUME ALT (0xC2).
Four CD-ROM drives are now emulated;
ATAPI DMA is now emulated;
Unified CD-ROM pass through to host drive handling;
Applied all (applicable) mainline PCem commits.
Added experimental NVidia Riva TNT2 emulation (patch from MoochMcGee);
ASUS P/I-P54TP4XE, ASUS P/I-P55T2P4, and ASUS P/I-P55TVP4 are back;
National Semiconductor PC87306 Super I/O chip now correctly reenables devices after a chip power cycle;
Several FDC improvements and the behavior is now a bit closer to real hardware (based on actual tests);
Added MR Intel Advanced/ATX with Microid Research BIOS with support for 4 floppy drives and up to 4 IDE controllers;
Added floppy drives 3 and 4, bringing the maximum to 4;
You can now connect hard disks to the tertiary IDE controller;
Correct undocumented behavior of the LEA instruction with register is back on 286 and later CPU's;
Pentium-rea models with Intel chipsets now have port 92 (with alternate reset and alternate A20 toggle);
Overhauled DMA channel read and write routines and fixed cascading;
Improved IMG detection of a bad BPB (or complete lack of a BPB);
Added preliminary emulation of PS/2 1.44 MB and PC-98 1.25 MB 3-mode drives (both have an inverted DENSEL pin);
Removed the incorrect Amstrad mouse patch from TheCollector1995;
Fixed ATAPI CD-ROM disk change detection;
Windows IOCTL CD-ROM handler now tries to use direct SCSI passthrough for more things, including obtaining CD-ROM capacity;
The Diamond Stealth32 (ET4000/W32p) now also works correctly on the two Award SiS 496/497 boxes;
The (S)VGA handler now converts 6-bit RAMDAC RGB channels to standard 8-bit RGB using a lookup table generated at emulator start, calculated using the correct intensity conversion method and treating intensity 64 as equivalent to 63;
Moved a few options from the Configuration dialog box to the menu;
SIO, PIIX, and PIIX3 now have the reset control register on port CF9 as they should;
Several bugfixes.
FDI stream images are now also handled by the 86F handler;
Both floppy drives' motors now spin separately;
Added Plantronics ColorPlus emulation per patch from PCem forum;
Applied all mainline PCem commits;
Fixed several bugs.
Improved TeleDisk support;
Added support for ImageDisk (IMD) images;
Added MSR registers 186 and 570 for the Intel i686 CPU's;
Applied both mainline PCem commits.
Cleaned up floppy code a lot and reverted to single poller;
Fixed segment present bit and limit checking at read/write within segment;
The ASUS boards now have memregs too;
RTC code improved based on suggestion by Sarah Walker;
Fixed SVGA odd/even emulation and added chain odd/even support;
Removed non-existent CPU's.
